Master thesis and internship[BR]- Master's thesis : Simulation of a wingtip vortex flow with Linear Eddie Viscosity turbulence models at Re = 4.6E6 and Re = 1.2E6[BR]- Integration Internship

Abstract

This work studies the accuracy of Linear Eddie Viscosity models on the prediction of wingtip vortex flow. The geometry selected for the study is a NACA-0012 half wing mounted at the wall, with a rounded end cap and trailing edge, inclined by 10° at its quarter chord.

Computations of the flow were conducted using the open source software SU2. Two turbulence closures were investigated: the Negative Spalart-Allmaras and the Menter's Shear Stress Transport models. The flow was considered at two Reynolds numbers : Re = 4.3 x 10E6 and Re = 1.2 x 10E6. To study the models' accuracy, the initial objective of the work was to produce high-fidelity LES data using the software ARGO provided by Cenaero. However, due to the setup of the simulations and the computing time requirements, we fail to obtain LES simulations of the entire wing. Therefore, the computed flow is compared against the experimental and numerical data found in the literature.

The results showed that LEVM could characterize the main vortical structures' topology and surface flow quantities. However, they fail to predict the evolution of the mean quantities on the vortex core. This divergence between the numerical simulations and the experimental results was associated with the eddie viscosity, which caused a diffusion of the mean quantities, and the models' assumptions, which cannot correctly represent the Reynold stress and strain rate tensors misalignment observed in the experimental data.

Although we could not fulfill the project's initial objective, we were still able to provide indications of possible future work based on comparing the RANS results with the reference experimental and numerical data.